Professional Dryer Vent Hose Replacement Services in San Angelo, TX
At San Angelo Air Duct Cleaning, we replace dryer vent hoses and leave the area behind the dryer clean. Our technicians pull the dryer out and disconnect the old hose. Lint is vacuumed from the floor, the wall opening, and the dryer outlet. We inspect the wall collar and resecure it if needed. A new semi-rigid metal hose is installed, clamped, and sealed with foil tape. The hose is cut to length so it doesn't sag or kink. We return the dryer to its spot and level it if it was moved off balance. Airflow is tested when the dryer runs. The specific dryer vent hose replacement services we provide in San Angelo are listed below.
Dryer Exhaust Hose Replacement in San Angelo
The exhaust hose connects the dryer outlet to the wall duct, and it takes the most abuse because the machine gets moved for cleaning and repairs. Our technician inspects the hose for tears, heat damage, and lint packed in its ridges, then disconnects it at both ends. We clean the dryer outlet collar and the wall duct opening before fitting the new hose. The replacement is a 4-inch semi-rigid aluminum duct cut short enough to avoid sagging behind the dryer. Metal worm-gear clamps hold each end tight, and the technician checks that the dryer sits back without crushing the duct. Your dryer pushes air out freely, and loads dry faster.
Dryer Vent Pipe Replacement in San Angelo
Rigid dryer vent pipe inside walls and ceilings can rust, separate at the joints, or get crushed during remodeling work. Our dryer vent replacement team locates the damaged section with an inspection camera and opens the nearest access point to reach it. We remove the failed pipe and install a new 4-inch rigid pipe with the male ends pointing in the direction of airflow so the lint slides past each joint. Each joint gets sealed with foil tape instead of screws, since screw tips catch lint inside the pipe. The crew closes the access opening once the new section passes an airflow check. Hot exhaust then travels through the wall without leaking into the cavity.
Dryer Vent Duct Replacement in San Angelo
Some dryer vent runs need full replacement because the original duct was too long, used flexible material inside the wall, or has too many elbows to move air. Our dryer vent cleaning service team measures the existing run and counts each elbow to calculate its equivalent length against the code and the dryer manufacturer's limit. We plan a shorter route when possible, often moving the termination to a closer exterior wall or through the roof. The crew removes the old duct, installs new rigid pipe with long-radius elbows, and supports each section so it cannot sag. A new exterior hood with a backdraft damper completes the run. The dryer finishes loads in a single cycle, and the laundry room stays cooler.
Periscope Dryer Vent Installation in San Angelo
Dryers pushed close to the wall leave almost no room for a hose, and even a new semi-rigid duct can flatten in that space. Our dryer vent hose installation team measures the offset between the dryer outlet and the wall connection to size an adjustable periscope vent. The periscope's flat rigid profile lets the dryer sit just a few inches from the wall. We attach the lower section to the dryer outlet, slide the upper section to meet the wall duct, and secure both ends with clamps. Foil tape seals the telescoping joint so lint cannot escape. Your laundry area gains floor space, and the vent connection stays open however far back the dryer sits.
Recessed Dryer Vent Box Installation in San Angelo
A wall duct that sticks straight out forces the hose into a tight bend behind the dryer. Our technician cuts an opening between the wall studs and installs a recessed dryer vent box, which sets the connection inside the wall cavity. The box connects to the existing vent pipe from the back and gives the hose a straight path from the dryer outlet. We seal the box to the drywall and confirm the pipe inside the wall is clear before closing the work area. This installation suits laundry closets and hallways with limited depth. The dryer sits closer to the wall, and the hose runs without kinks.
Gas Dryer Vent Hose Replacement in San Angelo
Gas dryers send combustion gases, including carbon monoxide, out through the exhaust hose, so a torn hose can leak those gases indoors. Our technician shuts off the gas valve before moving the dryer and checks the flexible gas connector for kinks or wear. We replace the damaged exhaust hose with metal transition duct and confirm a tight connection at both ends. After reconnecting the gas line, the technician tests every fitting with leak detector solution and checks the laundry room with a carbon monoxide meter while the dryer runs. The crew also confirms the exterior hood opens fully under exhaust pressure. Your gas dryer vents its exhaust fully outdoors, and the laundry room air stays safe to breathe.
Stackable Dryer Hose Replacement in San Angelo
Stackable washer and dryer units sit in narrow closets where the exhaust hose gets pinched between the machine and the back wall. Our roof dryer vent cleaning team slides the stacked unit forward carefully, supports it to prevent tipping, and removes the damaged hose. We measure the vertical and horizontal offset to the wall duct and fit a short semi-rigid duct or a slim periscope that suits the closet depth. Each end gets clamped, and the technician checks that the unit slides back without compressing the new duct. Water and drain lines get checked for leaks before the unit returns to its space. The stacked dryer vents freely inside the tight closet, and drying times drop.
Exterior Dryer Vent Hood Replacement in San Angelo
Outdoor vent hoods crack in the sun, lose their flaps, or clog with lint and nests, which forces exhaust back up the hose. Our lint trap cleaning team removes the old hood, cleans lint from the exposed duct end, and checks the wall opening for water damage. We install a new hood with a gravity damper and no screen, since screens trap lint and building codes prohibit them on dryer exhaust. The hood gets sealed to the siding or stucco with exterior-grade sealant to keep rain out. The technician runs the dryer and confirms the flap opens fully and closes when the cycle ends. Exhaust leaves the house freely, and pests no longer enter through the vent opening.
Dryer Vent Hose Replacement Near Me in San Angelo, TX
Homeowners searching for dryer hose replacement near me usually need the fix done before the next load of laundry. San Angelo Air Duct Cleaning replaces dryer hoses across San Angelo and nearby areas including Santa Rita, Lake Nasworthy, and Bentwood with vans stocked with duct, clamps, and periscope fittings. Call (325) 770-1999 to book a same-day replacement.
About Our City San Angelo
We proudly support the San Angelo community with air duct and vent cleaning services for houses, apartments, offices, and other occupied buildings. Whether you are near Santa Rita, living around Lake Nasworthy, or managing a property in Bentwood, we can assist with dust and debris buildup in the ductwork serving your heating and cooling system. Our approach emphasizes careful inspection, thorough cleaning of accessible components, and service recommendations matched to the condition of the property's ventilation system. We tailor our work to the ventilation components and access available in each property.
Dryer Vent Hose Replacement Cost in San Angelo, TX
Dryer vent hose replacement is one of the lowest-cost dryer safety upgrades, since the job covers only the short connector between the dryer and the wall. Most homeowners pay $75 to $175 for a replacement with a semi-rigid or rigid metal hose, including clamps and labor. San Angelo Air Duct Cleaning prices start, and adding a full vent cleaning in the same visit comes at a reduced rate.
| Service | What's Included | Typical Cost |
|---|---|---|
| Semi-rigid metal hose | Old hose removal, new hose, two clamps | $75 to $140 |
| Rigid metal connector | Custom-fit rigid pipe, elbow, foil tape | $110 to $200 |
| Periscope vent for tight spaces | Low-profile periscope for flush installs | $120 to $220 |
| Stacked unit hose replacement | Unit pull-out, compact hose | $120 to $200 |
| Hose replacement plus cleaning | New hose, full vent brushing | $160 to $280 |
| Wall collar repair | Collar reattachment, sealing | $60 to $120 |
